This study updates previous IIHS studies comparing estimated delta Vs for crash tested vehicles to the distribution of estimated delta Vs in the National Automotive Sampling System (NASS) Crashworthiness Data System (CDS). The delta V estimates for 232 frontal crash tests at 64.4km/h into a deformable barrier with 40 percent overlap are compared with estimates from frontal offset crashes in the 1997-2004 NASS database. All delta V estimates were based on SMASH, the delta V estimating program used by NASS since 1997. Results indicated that for all vehicles tested by IIHS, SMASH delta Vs were, on average, 32 percent lower than impact speeds and about 28 percent lower than the expected delta V. Almost 80 percent of all real-world frontal crashes resulting in AIS 3+ injuries and just over 60 percent of all fatal crashes occur at or below the average estimated delta V calculated for crash tested vehicles.
Um ein Bild von der aktuellen Messunsicherheit bei der Bestimmung von Tetrahydrocannabinol (THC) in Serum zu erhalten, wurden von sieben forensisch-toxikologischen Laboren rechtsmedizinischer Institute Daten der letzten Jahre erhoben. Zur Abschätzung der Messunsicherheit wurde eine Einteilung in zufällige Fehler (Präzision) und systematische Fehler (Richtigkeit) vorgenommen. Ergebnisse zur Richtigkeit wurden aus Daten von Ringversuchen ermittelt. Es ergab sich eine mittlere erweiterte Messunsicherheit für die THC-Bestimmung von ca. 33 %, das heisst, bei einem Messwert von 1 ng/ml liegt der "wahre Wert" mit circa 95 prozentiger Wahrscheinlichkeit im Intervall zwischen 0,67 und 1,33 ng/ml. Dieses Ergebnis bestätigt, dass die verwendete Analytik geeignet ist, bei Konzentrationen um 1 ng/ml einen sicheren Substanznachweis zu führen. Es ist erkennbar, dass bei der THC-Bestimmung im Serum in der Regel der Richtigkeitsanteil an der Messunsicherheit größer ist als der Präzionsanteil.
Bone fracture patterns could be crucial in reconstructing the nature of loading, especially in the lower limb and upper limb kinematics in vehicle-pedestrian crashes. In addition, use of FE bone models can be a handy tool to predict vehicle impact velocity and the impact direction. The point of fracture initiation in bone loading has been predicted quite accurately earlier. A methodology that predicts bone crack initiation and its propagation pattern for the six known loading directions using a single material and failure model is presented.
In order to improve the protection of children transported in cars, within the CHILD programme (GR3D-CT2002-00791) real world road accidents are thoroughly analysed and then reconstructed in laboratory. Prior to comparing injury severities of real victims to physical parameter values measured on the dummies, the quality of the reconstructions is evaluated by experts who use their experience based on the investigation of numerous and various accidents. This paper presents a new tool aiming at better evaluating and validating accident reconstructions. It is based on statistical evaluation of vehicle deformations which gives weighing factors for every part of the car body structure finally leading to a specific Reconstruction Quality Score (RQS indicator). Furthermore, the reliability of this score, depending on the number of measured points, can be established. This tool includes a function aiming at adjusting the speed for a further reconstruction and at defining the launching speed and the pulse shape for complementary sled tests. Finally, the functions of the RQS software and database are presented.
Nach Anlage 5 (2) der Fahrerlaubnisverordnung (FeV) verlangt der Gesetzgeber von Bewerbern um die Erteilung oder Verlängerung einer Fahrerlaubnis der Klassen D, D1, DE, D1E sowie der Fahrerlaubnis zur Fahrgastbeförderung die Erfüllung besonderer Anforderungen hinsichtlich Belastbarkeit, Orientierungsleistung, Konzentrationsleistung, Aufmerksamkeitsleistung sowie Reaktionsfähigkeit. Die zur Untersuchung dieser Merkmale eingesetzten testpsychologischen Verfahren müssen nach dem Stand der Wissenschaft standardisiert und unter Aspekten der Verkehrssicherheit validiert sein. Zur Klärung der Fragen, wie ausgedehnt das Spektrum eingesetzter und akzeptierter Testverfahren ist und welche Erfahrungen die Gutachter bisher gemacht haben, fand am 07.11.2000 in der Bundesanstalt für Straßenwesen ein Expertengespräch statt. Dieses Gespräch zeigte unter anderem folgende Ergebnisse: Zum Einsatz kommen insbesondere das Act-and-React-Testsystem (ART) und das Wiener Testsystem (WTS), weiterhin die Testbatterien zur Aufmerksamkeitsprüfung (TAP). Die als Grenzwerte festgelegten Prozentränge von 33 beziehungsweise 16 sind empirische Setzungen, als Referenz wurden bewusst altersunabhängige Normwerte gewählt. In einigen Bundesländern sind die Begutachtungsstellen für Fahreignung erste Anlaufstellen, in anderen die Betriebs- oder Arbeitsmediziner. Die Durchführung der Testverfahren kann durch einen qualifizierten Arzt, Psychologen oder eine geschulte Testassistentin erfolgen. Sobald sich die Frage einer Kompensationsprüfung stellt, ist eine differenzierte psychologische Untersuchung erforderlich. Bei unauffälligen Befunden kann das Gutachten weitgehend standardisiert sein. Abschließend sind Forderungen für die weitere Entwicklung formuliert.
The current Brussels EU Regulation No. 1235/2011, valid from May 30, 2012, has introduced an European Tyre Label with wet grip index G classes from A to G for passenger car tyres C1, light commercial vehicles tyres C2 and heavy truck- and bus tyres C3. Every wet grip class for each vehicle category has a defined band of numerical values for the wet grip index G. The legislated wet grip values G in this EU- Regulation are very low. The measured braking distances and corresponding impact speeds of the test vehicles are showing very critical results. Regulation No. 1235/2011 of the European Parliament and the Council for Type Approval of Vehicles (EU) should be changed in such a way, that for C1-tyres (normal passenger cars tyres) the minimum wet grip index G is 1.25. All C2-tyres (light commercial vehicles tyres) should at least meet a minimum wet grip index of G = 1.1. All C3-tyres (heavy trucks and buses tyres) should at least meet a minimum wet grip index of G = 0.95. Due to the missing lower limits for G in the wet grip class F for C1, C2 and C3 tyres according to Commission Regulation (EU) No. 1235/2011, officially valid from 30 May 2012, a tyre-to-road coefficient of adhesion in the extreme of 0 (zero) is legally permitted. This is an apparent flaw in above cited EU Regulation, which causes a potential danger to the road traffic safety for all motor vehicles in Europe with such tyres. The wet grip class F has to be removed urgently from said EURegulation, since a direct liability of the responsible EU-Commission can not be excluded.
In order to enable foreseeing or comparing the benefit of safety systems or driver assistance systems in Germany, in the United States and in Japan, the traffic accident databases in those three countries are examined. The variables used are culpable party, collision partner, accident type, and injury level and the method to re-classify the databases for comparison are proposed. The result indicates that single passenger car fatality is the most frequent in Germany and in the United States, while passenger car vs. pedestrian is the most frequent fatality scenario in Japan. When the casualty by fatality ratio is focused, the greatest difference is observed in rear-end collisions. The ratio of slight injuries in Japan yields about eighteen times as many as those in Germany, and about eight times as many as those in the United States.
The objective was to develop and validate a crash trolley (reference vehicle) equipped with a compartment and a full restraint system for driver and front seat passenger which can be used in full scale crash testing. Furthermore, the crash trolley should have a suspension to show rotation and nick effects similar to real vehicles. Within the development phase the reference vehicle was build based on a European family car. Special attention was needed to provide appropriate strength to the trolley and its suspension. The reference vehicle is equipped with a restraint system consisting of airbags, pedals, seats, dashboard, and windscreen. On the front of the vehicle different crash barriers can be installed to provide miscellaneous deceleration pulses. For the validation phase a series of low and high speed crash tests with HIII dummies were conducted and compared with full scale tests. For the comparison deceleration pulse, dummy numbers and vehicle movement were analyzed. Validation tests with velocities up to 60 km/h showed promising results. The compartment and the suspension systems stayed stable. Rotation effects were comparable with full scale car crash tests. The airbags and seat belt system worked reasonable. The acceleration pulse compared to an Euro NCAP test had a similar characteristic but was in general slightly lower. After the successful validation the reference vehicle is already in use in different studies in the field of vehicle safety research at BASt.
Detailed anthropometric data of pregnant women have been collected and used in the development of a computational model of the pregnant occupant model "Expecting". The model is complete with a finite element uterus and multi-body fetus, which is a novel feature in the models of this kind. The computational pregnant occupant model has been validated and used to simulate a range of impacts. The strains developed in the utero-placental interface are used as the main criteria for fetus safety. Stress distributions due to inertial loading of the fetus on the utero-placental interface play a role on the strain levels. Inclusion of fetus model is shown to significantly affect the strain levels in the utero-placental interface. This series of studies has led to the design of seatbelt features specifically for the pregnant women to enable them use the seatbelt correctly and comfortably.
In 2014 the sixth ESAR conference (Expert Symposium on Accident Research) was held in Hannover. ESAR is an international convention of experts, who analyze traffic accidents all over the world and discuss their results in this context, conducted at the Medizinische Hochschule Hannover every 2 years. It connected representatives of public authorities, engineers in automotive development and scientists and offers a forum with particular emphasis on In-Depth-Analyses of accident statistics and accident analyses. Special focus is placed on research on the basis of so-called "In-Depth-Accident-Investigations" [data collections at the sites of the accidents], which are characterized by extensive documentations of the sites of the accidents, of the vehicles as well as of the injuries, encompassing several scientific fields. ESAR aims at a multi-disciplinary compilation of scientific results and at discussing them on an international, scientific level. It is thus a scientific colloquium and a platform for exchanging information for all accident researchers. Experiences in accident prevention as well as in the complex field of accident reconstruction are stated and new research fields are added. Existing results of long-term research work in Europe, the US, Australia and Japan include different infrastructural correlations and give findings on population, vehicle population and driver characteristics, which offer a basis for recommendations to be derived and measures for increasing road safety.