Abteilung Fahrzeugtechnik
Filtern
Erscheinungsjahr
Dokumenttyp
Sprache
- Englisch (90)
- Deutsch (51)
- Mehrsprachig (1)
Volltext vorhanden
- nein (142) (entfernen)
Schlagworte
- Safety (53)
- Sicherheit (53)
- Anfahrversuch (38)
- Vehicle (37)
- Bewertung (36)
- Evaluation (assessment) (36)
- Fahrzeug (36)
- Impact test (veh) (35)
- Test method (31)
- Prüfverfahren (29)
Institut
Road markings are an essential component of a safe road. In particular, the optical guidance at night and under wet conditions rates high. Special surface textures of road markings can enhance the nighttime visibility during wetness, but they can lead on the other hand to noise emission during passages of vehicles and thus annoy residents. In the present study the tyre/road marking noise is analysed based on two different measurement methods for traffic noise: Several different road markings with increased nighttime visibility during wetness were overrun and the noise was determined by controlled coast-by measurements as well as close-proximity measurements. For both measuring methods the averaged A-weighted sound pressure levels were determined and an analysis of the third octave spectra was performed in order to identify annoying tonal components. The results of both measurement methods were compared with each other. Limitations of the individual measurement methods were overcome by combining the data. Properties of road marking noise depending on the texture of the marking are discussed in relation to those of road surface noise. The results will help specifying road marking texture types that ensure less annoyance and at the same time good visibility at wetness and night-time.
In the European Project FIMCAR, a proposal for a frontal impact test configuration was developed which included an additional full width deformable barrier (FWDB) test. Motivation for the deformable element was partly to measure structural forces as well as to produce a severe crash pulse different from that in the offset test. The objective of this study was to analyze the safety performance of vehicles in the full width rigid barrier test (FWRB) and in the full width deformable barrier test (FWDB). In total, 12 vehicles were crashed in both configurations. Comparison of these tests to real world accident data was used to identify the crash barrier most representative of real world crashes. For all vehicles, the airbag visible times were later in the FWDB configuration. This was attributed to the attenuation of the initial acceleration peak, observed in FWRB tests, by the addition of the deformable element. These findings were in alignment with airbag triggering times seen in real world crash data. Also, the dummy loadings were slightly worse in FWDB compared to FWRB tests, which is possibly linked to the airbag firing and a more realistic loading of the vehicle crash structures in the FWDB configuration. Evaluations of the lower extremities have shown a general increasing of the tibia index with the crash pulse severity.
Die Initiative der Einführung kooperativer Systeme in einem Korridor von Rotterdam über Frankfurt/Main nach Wien, dem sogenannten C-ITS Corridor, und damit auch in Deutschland wurde im Juni 2013 durch die Unterzeichnung einer entsprechenden Absichtserklärung des Bundesministeriums für Verkehr, Bau und Stadtentwicklung mit den Verkehrsministern der Niederlande und Österreichs offiziell gestartet. In vielen Forschungsprojekten wurden vorher die Grundlagen erarbeitet, um eine solche Einführung technisch überhaupt erst möglich zu machen. Im Beitrag werden diese Ergebnisse nochmals kurz aufgegriffen und um den aktuellen Stand bei den Entwicklungen im C-ITS Corridor erweitert. Als erstes Einführungsszenario wurden die Baustellenwarnung und Kooperatives Verkehrsmanagement unter Einbeziehung von Fahrzeugdaten gewählt. Nicht verschwiegen werden sollen hierbei auch die wesentlichen Herausforderungen, die im Übergang von Forschung und Feldtests zu realen Anwendungen liegen.
Müdigkeit am Steuer ist eine bedeutsame Ursache von Straßenverkehrsunfällen. Es steht eine Fülle unterschiedlicher Methoden zur Verfügung, um Müdigkeit beim Fahrer zu erkennen. Ziel des vorliegenden Projekts war es, auf Basis einer mehrstufigen Befragung von zwölf Experten aus Industrie- und Hochschulforschung die Stärken und Schwächen der derzeit validesten objektiven Müdigkeitsmessverfahren vergleichend zu beschreiben. Als Basis der Bewertung diente ein eigens erarbeiteter Gütekriterienkatalog. Zu den validesten Müdigkeitsmessverfahren gehören aus Expertensicht Lenkverhalten und Spurhaltung, Indikatoren des Lidschlussverhaltens und des EEG, das videobasierte Expertenrating sowie der kontrovers diskutierte Pupillografische Schläfrigkeitstest. Die Güteprofile der sechs ausgewählten Messverfahren werden aufgeführt. Je nach Einsatzgebiet sind alle ausgewählten Messverfahren (Forschung und Entwicklung), nur einige (Müdigkeitswarnsystem im Fahrzeug), oder kein einziges (Verkehrskontrolle) geeignet. Dem Urteil der Experten nach bedarf eine valide Müdigkeitserfassung der Kombination von mindestens zwei Messverfahren unter Berücksichtigung der spezifischen Stärke-Schwächenprofile.
Within the automotive context camera monitor systems (CMS) can be used to present views of the traffic situation behind the vehicle to the driver via a monitor mounted inside the cabin. This offers the opportunity to replace classical outside rearview mirrors and therefore to implement new design concepts, aerodynamically optimized vehicle shapes and to reduce the width of the vehicle. Further, the use of a CMS offers the potential to implement functionalities like warnings or situation-adaptive fields of view that are not feasible with conventional rearview mirrors. Despite these potential advantages, it is important to consider the possible technical constraints of this technology and its effect on driver perception and behavior. On the technical side next to the field of view and die robustness of die system, aspects as its functionality at day and night as well as under varying weather conditions should be object to scientific investigation. Concerning human machine interaction, it has to be considered, that the perception of velocities and distances of approaching vehicles might be different for CMS as compared to conventional rearview mirrors and potential influences of factors as the Position of the displays or drivers' age should be taken into account. In order to shed light on these and further open issues, BASt is currently conducting a study that will cover the use of CMS under controlled conditions as well in real traffic. The first part of the study will focus on passenger cars, while in a second step the empirical investigation will be extended to heavy goods vehicles, where the potentials as well as the limitations of CMS might differ considerably. The presentation will cover the first part, with regard to the experimental design, implementation and initial results if already available.
Economic constraints nowadays require transporting greater volumes of freight at lower cost. Yet, physical profiles of trucks do not all generate the same effects on road infrastructure for a given tonnage hauled. The objective then lies in finding an optimal service level that reduces the damage caused to infrastructure. Results derived for the impact of trucks on pavements are presented. The impact of truck traffic trends on road bridges will also be discussed.rn
Aus wissenschaftlichen Untersuchungen ist bekannt, dass ältere Menschen trotz ihrer langen Fahrerfahrung in spezifischen Verkehrssituationen Fahrfehler und Unsicherheiten zeigen. In zwei Experimenten an jüngeren und älteren Versuchsteilnehmern wurde im Ergonomie-Labor der Bundesanstalt für Straßenwesen (BASt) versucht, den Ursachen spezifischer Fahrfehler älterer Kraftfahrer nachzugehen. Die Ergebnisse lieferten wichtige Ansatzpunkte für die Entwicklung von Fahrerassistenzsystemen (FAS), indem Erkenntnisse zu visuellen Aufmerksamkeitsleistungen gesammelt wurden. Im Rahmen eines Doppeltätigkeitsparadigmas wurde der visuell-räumliche Aufmerksamkeitsprozess, der für das Führen von Kraftfahrzeugen von wesentlicher Bedeutung ist, nicht nur auf der Verhaltensebene, sondern auch neurophysiologisch durch die Ableitung der Hirnströme mittels EEG untersucht. Hauptaufgabe war in beiden Experimenten eine Spurhalteaufgabe, die kurvenreiches Fahren simulieren sollte. Nebenaufgabe war jeweils eine Lichtreizaufgabe, bei der so schnell wie möglich durch Tastendruck auf einen Lichtreiz reagiert werden musste. Im zweiten Experiment wurde überprüft, ob bei der Lichtreizaufgabe die Verschlechterung der Aufmerksamkeitsleistung graduell erfolgt, indem bei den Lichtreizen die Exzentrizität erweitert wurde. Die Reize wurden bilateral, in abgestufter Form in verschiedenen Sehwinkeln von der Fovea centralis präsentiert. Dargestellt werden die Versuchsdurchführung sowie die Ergebnisse für die Verhaltensdaten und die festgestellten ereigniskorrelierten Potenziale (EKP). Es zeigte sich, dass durch die Berücksichtigung zusätzlicher weiterer Exzentrizitäten die Ergebnisse der Vorgängerstudie in bedeutsamer Weise erweitert werden konnten. Für beide Gruppen zeigten sich über den Verlauf hinweg klare Anzeichen für den Verlauf kompensatorischer Prozesse, die sich für die Älteren aber nur bis zu einem Sehwinkel von 50 Grad darstellten. Bei Reizen im Sehwinkel von 60 Grad war die Detektionsleistung deutlich schlechter, vor allem bei den älteren Versuchsteilnehmern. Außerdem wurde festgestellt, dass vor allem die Älteren Beeinträchtigungen in der Detektionsleistung zeigen, wenn der Abstand zwischen zwei Reizen gering ist. Es zeigt sich, das im Hinblick auf das Übersehen von Verkehrsobjekten, das eine wesentliche Ursache von Unfällen älterer Fahrer darstellt, diese technisch - beispielsweise bei Wende- oder Abbiegeprozessen - durch einen Sehfeldassistenten unterstützt werden können. Da Ältere durch schnelle Reaktionsabfolgen stärker beansprucht werden, sind Systeme mit Warnfunktion oder teilautomatisierte Systeme eher kritisch zu sehen, da sie zusätzlichen Bedien- beziehungsweise Überwachungsaufwand erfordern.
To improve vehicle safety in frontal collisions, the crash compatibility between the colliding vehicles is crucial. Compatibility aims to improve both the self and partner protection properties of vehicles. Although compatibility has received worldwide attention for many years, no final assessment approach has been defined. Within the Frontal Impact and Compatibility Assessment Research (FIMCAR) project, different frontal impact test procedures (offset deformable barrier [ODB] test as currently used for Economic Commission for Europe [ECE] R94, progressive deformable barrier test as proposed by France for a new ECE regulation, moveable deformable barrier test as discussed worldwide, full-width rigid barrier test as used in Federal Motor Vehicle Safety Standard [FMVSS] 208, and full-width deformable barrier test) were analyzed regarding their potential for future frontal impact legislation. The research activities focused on car-to-car frontal impact accidents based on accident investigations involving newer cars. Test procedures were developed with both a crash test program and numerical simulations. The proposal from FIMCAR is to use a full-width test procedure with a deformable element and compatibility metrics in combination with the current offset test as a frontal impact assessment approach that also addresses compatibility. By adding a full-width test to the current ODB test it is possible to better address the issues of structural misalignment and injuries resulting from high acceleration accidents as observed in the current fleet. The estimated benefit ranges from a 5 to 12 percent reduction of fatalities and serious injuries resulting from frontal impact accidents. By using a deformable element in the full-width test, the test conditions are more representative of real-world situations with respect to acceleration pulse, restraint system triggering time, and deformation pattern of the front structure. The test results are therefore expected to better represent real-world performance of the tested car. Furthermore, the assessment of the structural alignment is more robust than in the rigid wall test.
Verschiedene Forschungsprojekte aus dem Bereich Kooperativer Systeme, die vor Kurzem gestartet sind, beschäftigen sich unter anderem mit den organisatorischen Aspekten einer Gesamtarchitektur. Eine Organisationsarchitektur beschreibt dabei die Rollen und Verantwortlichkeiten, die im Betrieb unterschiedlicher Kooperativer Anwendungen auftreten. In den Projekten erfolgt zumeist eine Betrachtung der Organisationsarchitektur anhand konkreter Implementierungsszenarien oder Use Cases. Der im Bericht dokumentierte aktuelle Stand der abstrakten Beschreibung der Rollen und Verantwortlichkeiten soll den Projekten und Initiativen als Diskussionsgrundlage und Ausgangspunkt für die Erarbeitung einer möglichen Organisationsarchitektur Kooperativer Systeme und deren Ausgestaltung dienen.
The strong prevalence of human error as a crash causation factor in motorcycle accidents calls for countermeasures that help tackling this issue. Advanced rider assistance systems pursue this goal, providing the riders with support and thus contributing to the prevention of crashes. However, the systems can only enhance riding safety if the riders use them. For this reason, acceptance is a decisive aspect to be considered in the development process of such systems. In order to be able to improve behavioural acceptance, the factors that influence the intention to use the system need to be identified. This paper examines the particularities of motorcycle riding and the characteristics of this user group that should be considered when predicting the acceptance of advanced rider assistance systems. Founded on theories predicting behavioural intention, the acceptance of technologies and the acceptance of driver support systems, a model on the acceptance of advanced rider assistance systems is proposed, including the perceived safety when riding without support, the interface design and the social norm as determinants of the usage intention. Since actual usage cannot be measured in the development stage of the systems, the willingness to have the system installed on the own motorcycle and the willingness to pay for the system are analyzed, constituting relevant conditions that allow for actual usage at a later stage. Its validation with the results from user tests on four advanced rider assistance systems allows confirming the social norm and the interface design as powerful predictors of the acceptance of ARAS, while the extent of perceived safety when riding without support did not have any predictive value in the present study.