91 Fahrzeugkonstruktion
Filtern
Erscheinungsjahr
Dokumenttyp
Schlagworte
- Safety (67) (entfernen)
Institut
- Abteilung Fahrzeugtechnik (67) (entfernen)
In Germany the number of casualties in passenger car to pedestrian crashes has been reduced by a considerable amount of 40% as regards fatalities and 25% with regard to seriously injured pedestrians since the year 2001. Similar trends can be seen in other European countries. The reasons for that positive development are still under investigation. As infrastructural or behavioral changes do in general take a longer time to be effective in real world, explanations related to improved active and passive safety of passenger vehicles can be more relevant in providing answers for this trend. The effect of passive pedestrian protection " specified by the Euro NCAP pedestrian test result " is of particular interest and has already been analyzed by several authors. However, the number of vehicles with some valid Euro NCAP pedestrian score (post 2002 rating) was quite limited in most of those studies. To overcome this problem of small datasets German National Accident Records have been taken to investigate a similar objective but now based on a much bigger dataset. The paper uses German National Accident Records from the years 2009 to 2011. In total 65.140 records of pedestrian to passenger car crashes have been available. Considering crash parameters like accident location (rural / urban areas) etc., 27.143 of those crashes have been classified to be relevant for the analysis of passive pedestrian safety. In those 27.143 records 7.576 Euro NCAP rated vehicles (post 2002 rating) have been identified. In addition it was possible to identify vehicles which comply with pedestrian protection legislation (2003/102/EG) where phase 1 came into force in October 2005. A significant correlation between Euro NCAP pedestrian score and injury outcome in real-life car to pedestrian crashes was found. Comparing a vehicle scoring 5 points and a vehicle scoring 22 points, pedestrians" conditional probability of getting fatally injured is reduced by 35% (from 0.58% to 0.37%) for the later one. At the same time the probability of serious injuries can be reduced by 16% (from 27.4% to 22.9%). No significant injury reducing effect, associated with the introduction of pedestrian protection legislation (phase 1) was detected. Considerable effects have also been identified comparing diesel and gasoline cars. Higher engine displacements are associated with a lower injury risk for pedestrians. The most relevant parameter has been "time of accident", whereas pedestrians face a more than 2 times higher probability to be fatally injured during night and darkness as compared to daytime conditions.
Vor dem Hintergrund der derzeitigen Verkehrs- und Unfallsituation sowie verkehrsrechtlicher Vorschriften wurde durch Auswertung humanwissenschaftlicher und technischer Literatur eine Sachstandsbeschreibung erstellt, die die in Zusammenhang mit Auffahrunfällen und ihrer Verhinderung stehenden Aspekte aufzeigt. Als fahrzeugtechnische Hilfen zur Einhaltung eines ausreichenden Abstandes zwischen hintereinander fahrenden Fahrzeugen werden dabei vorrangig autarke Systeme - das sind solche, bei denen sich alle notwendigen Vorrichtungen im Fahrzeug befinden - betrachtet. Möglichkeiten und Grenzen der bekannten technischen Hilfsmittel, insbesondere der Abstandswarn- und Abstandsregelungseinrichtungen werden aufgezeigt. Es stellte sich heraus, dass den Warnstrategien sowie ihren Auswirkungen auf den Verkehrsablauf und die Verkehrssicherheit besondere Bedeutung zukommt. In diesem Zusammenhang werden auch Zielkonflikte, insbesondere zwischen Sicherheitsforderungen und Fahrerakzeptanz, deutlich. Im Teil I des Berichts erfolgt die zusammenfassende Beschreibung und kritische Wertung des Sachstandes. Im Teil II werden die Auswerteergebnisse zu den angesprochenen Fragenkomplexen im einzelnen dargestellt. Teil III enthält eine Kurzdokumentation der für die Erstellung des Berichts wesentlichsten Literaturstellen.
In der BRD hatten 1977 etwa 39.000 bis 46.000 Pkw einen Brandschaden durch Flammen- und/oder Glutwirkung. Der Sachschadenaufwand der Kraftfahrzeugversicherer betrug 52 Mio. DM. Schwere Personenschäden sind vorwiegend bei unfallbezogenen Fahrzeugbränden entstanden. 1977 wurden ca. 55 bis 80 Personen durch Fahrzeugbrand getötet, maximal 450 schwer verletzt. Etwa 90 % der Brände entstehen infolge technischer Mängel, Fahrlässigkeit und Brandstiftung. Auf Wunsch der Käufer werden etwa 10 % der Pkw mit tragbaren Feuerlöschern ausgerüstet. Der Zwei-Kilo-Löscher hat sich als derzeit günstiger Löscher herausgestellt. Welchem Löschmittel der Vorzug zu geben ist, wurde von Experten nicht eindeutig beantwortet. Die Gesamtwirksamkeit des Zusammenhanges Brandgeschehen-Mensch-Feuerlöschgerät verdeutlicht, dass eine allgemeine Ausrüstungspflicht aller Pkw mit tragbaren Feuerlöschern aus gesamtwirtschaftlicher Sicht nicht zu befürworten ist. Das freiwillige Ausrüsten von Fahrzeugen sollte dagegen weiter propagiert werden.
Erkenntnisse über den Nutzen zusätzlicher hochgesetzter Bremsleuchten sind lückenhaft und zum Teil widersprüchlich. Im Rahmen einer Untersuchung über den Einfluss zusätzlicher Bremsleuchten auf das Unfallgeschehen wurden u.a. folgende Fragen behandelt: 1. Entwicklung der Unfälle durch Auffahren auf Fahrzeuge, die mit zusätzlichen Bremsleuchten ausgerüstet sind, 2. Entwicklung der Auffahrunfälle insgesamt, 3. Verletzungen von Fahrzeuginsassen durch Leuchten, 4. Auswirkungen auf die übrigen Verkehrsteilnehmer (Abstand, Blendung, Fehlreaktion). Anhand konkreter Daten über das Unfallgeschehen in Bayern und Niedersachsen kommt der Beitrag insgesamt zu dem Urteil, dass die derzeitige Regelung weder durch eine Einbauvorschrift noch durch ein Einbauverbot hochgesetzter Bremsleuchten ersetzt werden müsste.
A means of assessing the passive safety of automobiles is a desirable instrument for legislative bodies, the automobile industry, and the consumer. As opposed to the dominating motor vehicle assessment criteria, such as engine power, spaciousness, aerodynamics and consumption, there are no clear and generally accepted criteria for assessing the passive safety of cars. The proposed method of assessment combines the results of experimental safety tests, carried out according to existing legally prescribed or currently discussed testing conditions, and a biomechanical validation of the loading values determined in the test. This evaluation is carried out with the aid of risk functions which are specified for individual parts of the body by correlating the results of accident analysis with those obtained by computer simulation. The degree of conformance to the respective protection criterion thus deduced is then weighted with factors which take into account the frequency of occurrence and the severity of the accident on the basis of resulting costs. Each of the test series includes at least two frontal and one lateral crash test against a deformable barrier. The computer-aided analysis and evaluation of the simulation results enables a vehicle-specific overall safety index as well as partial and individual safety values to be determined and plotted graphically. The passive safety provided by the respective vehicle under test can be defined for specific seating positions, special types of accident, or for individual endangered parts of the body.
The GRSP informal group on child restraint systems (CRS) finalised phase 1 of a new regulation for the homologation of CRS . This regulation is the subject of several discussions concerning the safety benefits and the advantages and disadvantages that certain specific points may bring. However, these discussions are sometimes not based on scientific facts and do not consider the whole package but only single items. Based on the experience of the CASPER partners in the fields of human behaviour, accident analysis, test procedures and biomechanics in the area of child safety, a consideration of the safety benefits of phase 1 of the new regulation and recommendations for phase 2 will be given.
The off-set assessment procedure potentially contributes to the FIMCAR objectives to maintain the compartment strength and to assess load spreading in frontal collisions. Furthermore it provides the opportunity to assess the restraint system performance with different pulses if combined with a full-width assessment procedure in the frontal assessment approach. Originally it was expected that the PDB assessment procedure would be selected for the FIMCAR assessment approach. However, it was not possible to deliver a compatibility metric in time so that the current off-set procedure (ODB as used in UNECE R94) with some minor modifications was proposed for the FIMCAR Assessment Approach. Nevertheless the potential to assess load spreading, which appears not to be possible with any other assessed frontal impact assessment procedure was considered to be still high. Therefore the development work for the PDB assessment procedure did not stop with the decision not to select the PDB procedure. As a result of the decisions to use the current ODB and to further develop the PDB procedure, both are covered within this deliverable. The deliverable describes the off-set test procedure that will be recommended by FIMCAR consortium, this corresponds to the ODB test as it is specified in UN-ECE Regulation 94 (R94), i.e. EEVC deformable element with 40% overlap at a test speed of 56 km/h. In addition to the current R94 requirements, FIMCAR will recommend to introduce some structural requirements which will guarantee sufficiently strong occupant compartments by enforcing the stability of the forward occupant cell. With respect to the PDB assessment procedure a new metric, Digital Derivative in Y direction - DDY, was developed, described, analysed, and compared with other metrics. The DDY metric analyses the deformation gradients laterally across the PDB face. The more even the deformation, the lower the DDY values and the better the metric- result. In order analyse the different metrics, analysis of the existing PDB test results and the results of the performed simulation studies was performed. In addition, an assessment of artificial deformation profiles with the metrics took place. This analysis shows that there are still issues with the DDY metric but it appears that it is possible to solve them with future optimisations. For example the current metric assesses only the area within 60% of the half vehicle width. For vehicles that have the longitudinals further outboard, the metric is not effective. In addition to the metric development, practical issues of the PDB tests such as the definition of a scan procedure for the analysis of the deformation pattern including the validation of the scanning procedure by the analysis of 3 different scans at different locations of the same barrier were addressed. Furthermore the repeatability and reproducibility of the PDB was analysed. The barrier deformation readings seem to be sensitive with respect to the impact accuracy. In total, the deliverable is meant to define the FIMCAR off-set assessment procedure and to be a starting point for further development of the PDB assessment procedure.
Um die zukünftige Entwicklung von Fahrzeugen mit alternativem Antrieb in Deutschland verfolgen, analysieren und mögliche negative Auswirkungen auf die Verkehrssicherheit zeitnah identifizieren zu können, hat die Bundesanstalt für Straßenwesen (BASt) im Jahr 2010 die Einrichtung einer langfristigen Beobachtung des Fahrzeugmarktes und des Unfallgeschehens von Pkw mit alternativen Antriebsarten initiiert. Die Daten des vorliegenden Berichtes dokumentieren die Marktdurchdringung von Personenkraftwagen mit alternativen Antriebsarten und informieren über die Unfallbeteiligung von Fahrzeugen mit alternativem Antrieb bis 2011. Es hat sich gezeigt, dass Fahrzeuge mit Hybridantrieb nach wie vor ein starkes Marktwachstum aufweisen. Die Zuwachsrate ist nahezu auf dem gleichen hohen Niveau wie in den Vorjahren (ca. 28%, getypter Bestand). Bei den reinen Elektrofahrzeugen ist die Anzahl getypter Fahrzeuge sehr stark angestiegen, von 212 im Jahr 2010 auf 1880 im Jahr 2011. Der reale Bestand an Elektrofahrzeugen (inklusive ungetypter Fahrzeuge) hat sich demgegenüber von 2010 auf 2011 auf 4.541 Pkw verdoppelt. Dies deutet auf eine zunehmende Serienreife von Elektro-Kfz hin. Pkw mit alternativem Antrieb weisen 2011 (bis auf Gas) einen höheren Anteil an Unfällen innerorts auf als Pkw mit herkömmlichem Antrieb. Hybrid Fahrzeuge haben dabei eine erhöhte Beteiligungsquote innerorts von ca. 76%. Der relativ hohe Anteil von Innerortsunfällen von alternativ betriebenen Fahrzeugen ist vor allem vor dem Hintergrund der Nutzung der Fahrzeuge zu interpretieren.
Sowohl mit dem 3. Road Safety Action Programme der Europäischen Kommission als auch mit dem deutschen Verkehrssicherheitsprogramm werden die verkehrspolitischen Zielsetzungen zur Erhöhung der Verkehrssicherheit in Europa und Deutschland festgelegt. Hierbei muss die passive Fahrzeugsicherheit auch weiterhin eine bedeutende Rolle übernehmen. Es ist jedoch auch festzustellen, dass durch den zunehmenden Einsatz von Elektronik im Fahrzeug die klassischen Bereiche der aktiven und passiven Fahrzeugsicherheit mehr und mehr ineinander greifen. Der Fortschritt in der Elektronik ermöglicht eine Integration der Systeme der aktiven und passiven Sicherheit. Dadurch lässt sich die Fahrzeugsicherheit weiter steigern. Durch die Vernetzung der Systeme lassen sich sogar Kosten einsparen. Der europäische Regierungsausschuss EEVC (European Enhanced Vehicle-safety Committee), die Verbraucherschutzorganisation Euro NCAP (European New Car Assessment Programme) und die Europäische Kommission mit der eSafety Initiative haben diesen Trend erkannt und entsprechende Aktivitäten eingeleitet.
The 2BeSafe project (2-Wheeler Behaviour and Safety) is a collaborative project (co financed by the European Commission) that aims to study the naturalistic behaviour of Powered-Two-Wheeler (PTW) riders in normal and critical riding situations. That includes the interaction between PTW riders and other road users and possible conflicts between them. One of the predominant causes of accidents involving PTWs is that PTWs are often overlooked by other road users. One task of the project lead by BASt therefore deals with possible improvements in conspicuity and the development of recommendations. Particularly using the findings of the studies on conflict situations, promising lighting arrangements to enhance conspicuity of PTWs during the day and at night are selected. An abstract recognizing pattern for PTWs is defined, enabling other road users (e.g. car drivers) to clearly identify riders. Lamps and outfit like lighting configurations of different colours, different helmet lights, reflect / luminescent clothing parts and retro-reflective markings are designed and manufactured. Then, the different solutions are tested in a laboratory setting using experimental motorcycles together with riders to which the equipment is fitted. As result a proposal for a uniform signal pattern or lamp configuration in the front of all motorcycles and riders will be outlined. The contribution first gives a short overview of the topics of the research project that deal with conflicts and their connection with poor conspicuity and then presents in detail the methods used in the activities concerning solutions for the improvement of conspicuity together with first results.