Sonstige
Filtern
Erscheinungsjahr
Dokumenttyp
Schlagworte
- Conference (329) (entfernen)
Institut
- Sonstige (329) (entfernen)
Relevant accident related factors : risk and frequencies of contributing to road traffic accidents
(2009)
In the course of the European Project TRACE (Traffic Accident Causation in Europe) an attempt was made to analyse the cause of road traffic accidents from a factors' point of view. By literature review the most important independent risk factors for traffic accidents were identified to be speed, alcohol intake, male gender, young age, cell phone use, and fatigue. However, the impact of an accident related factor also depends on its prevalence in traffic and accidents, respectively. Available to the Partners in the TRACE Project were different accident databases. Causally contributing factors found by accident investigations that are most often coded in accident databases are connected to unadapted speed and inattention. Taking into account the risk increase and the frequency of contribution to accidents the conclusion can be drawn that the most relevant factors for accident causation are: "alcohol", "speed", and "inattention and distraction".
Since the compulsory use of child restraints for children up to 5 years of age was introduced in 2000, restraint use among younger children has increased significantly. However, the observed rate of child restraint use plateaus at around 50%, and apparently little spillover effect has been found for older children who are not covered by the law. This report examines the restraint use patterns for children who were injured in cars in relation to driver and child passenger characteristics. Univariate and multivariate analyses were conducted to describe the association between the outcome measure (the proper use of restraints for children) and relevant variables. Better ways for parents and caregivers to improve the use of restraints for children are also discussed.
Diese Studie erfolgte als eine erste Prüfung der Frage, ob 0,1 Promille als Sicherheitszuschlag für eine Bestimmung eines Blutalkoholwertes von 0,1 Promille aus Gründen der Messunsicherheit angebracht und ausreichend ist. Beides trifft zu. Obwohl zur Zeit der Studie noch nicht bei oder unter 0,2 Promille kalibriert wurde, bestimmten alle Labors eine Blutalkoholkonzentration von 0,08 Promille mit einem Wert unter 0,18 g/L (Cmax ADH: 0,15 g/L = CmaxGC: 0,15 g/L = Blutalkoholkonzentration (BAK) von 0,12 Promille). Es bestand kein Bias zwischen beiden Verfahren. Festgestellte Standabweichungen: ADH: 0,021 g/L, GC: 0,025 g/L. Ein Sicherheitszuschlag von 0,1 Promille auf 0,1 Promille umfasst demnach vier Standardabweichungen und bietet für die neue Regelung im Paragrafen 24 Straßenverkehrsgesetz (StVG) bei der richtliniengemäß ausgeführten forensischen Blutalkoholbestimmung genügend Analysensicherheit.
Over 3,814 young drivers died in European Countries in 2004. Based on the recent OECD study: "Young drivers: the road to safety" (OECD, 2006), this paper addresses the question of the factors contributing to this high risk, and it draws together the experiences of many countries in reducing this risk. The comparisons across countries show that young driver safety is related to the quality of the traffic system. Safe countries have also safe young drivers, demonstrating that raising general safety levels is beneficial for young novice drivers. The analysis of the developments over time reveals that young males in contrast to young females have not benefited enough from the latest safety measures, indicating the need for a better understanding of the nature of the young male driver accident proneness. Although, recent studies on brain development indicate that youngsters may not be sufficiently physiologically matured to handle complex and dangerous tasks such as car driving, crash patterns indicate that enhanced driving experience may have protective effects. The paper closes with a 9 point policy plan. The full OECD report (258 pages) can be downloaded for free from http://internationaltransportforum.org/Pub/pdf/06YoungDrivers.pdf.
While cyclists and pedestrians are known to be at significant risk for severe injuries when exposed to road traffic accidents (RTAs) involving trucks, little is known about RTA injury risk for truck drivers. The objective of this study is to analyze the injury severity in truck drivers following RTAs. Between 1999 and 2008 the Hannover Medical School Accident Research Unit prospectively documented 43,000 RTAs involving 582 trucks. Injury severity including the abbreviated injury scale (AIS) and the maximum abbreviated injury scale (MAIS) were analyzed. Technical parameters (e.g. delta-v, direction of impact), the location of accident, and its dependency on the road type were also taken into consideration. The results show that the safety of truck drivers is assured by their vehicles, the consequence being that the risk of becoming injured is likely to be low. However, the legs especially are at high risk for severe injuries during RTAs. This probability increases in the instance of a collision with another truck. Nevertheless, in RTAs involving trucks and regular passenger vehicles, the other party is in higher risk of injury.
Rollover scenarios in Europe
(2005)
Rollover accidents seem to be a rising problem in Europe and therefore the systematic of this accident scenario should be investigated. Based on statistical investigations on major European accident databases for different countries a series of 73 real world rollover accidents was analysed. These cases were reconstructed using PC-Crash and preliminary categorised using a modified USbased rollover classification. In a first step, the rollover events were reconstructed from the point of conflict to the vehicle- rest position. The vehicles kinematics as well as its linear and rotational velocities were derived. In a second step typical velocity characteristics as well as kinematics were identified and the events categorised according to these criteria. Based on these results four main categories were defined, covering all reconstructed accidents. This categorisation was based on mechanical parameters (rotatory and translator kinematical data of the vehicle). Significant differences can be seen for different scenarios for the "first phase of rollover".
A concept for Safe-Driving-Trainings with a focus on risky behavior and safety related attitudes has been evaluated. 519 participants have been tested before and after the training by means of a questionnaire with the topics: technical driving competence, awareness of risks, and propensity for anticipation. A control group (131 subjects) was used to check for the possibility of response artifacts. Three months later, 92 members of the treatment group and 25 members of the control group have been tested again. The results show significant positive changes in driving competence, risk awareness, and safety related attitudes, especially anticipation, due to the training. Compared to the control group the participants have become more risk aware and they regard of risk avoiding behavior as more important. The results show that this concept for Safe-Driving-Trainings has not only short-term but, more importantly, long-term positive effects on the safety-relevant attitudes and cognitions of young drivers.
Automotive Engineering, Mechanical Engineering and TechnologyrnAbstract: The degrees of injury severity, as a rule injuries scaled by AIS of specific regions of the human body, investigated out of road traffic accidents correspond to the body-specific loading values, which are found out with the aid of experimental or mathematical simulation of crash tests with motor vehicles or with sled tests. The coherence between the injured human being on the one hand and the physical and the theoretical model respectively on the other hand is established by the risk function, which describes the probability of degrees of injury severity in dependence on the protection criteria. Due to the different physical characteristics in the simulation, e.g. accelerations, forces, compressions and their velocity, the compilation of these quantities, comparable to the MAIS, the maximal occurred single AIS obtained in accident analysis is much more difficult in the simulation than in the accident occurrence. Therefore it is obvious to normalize the loading values gained out of simulation and to summarise them to an entire value in a suitable manner, the safety index.rn
Safety of light goods vehicles - findings from the German joint project of BASt, DEKRA, UDV and VDA
(2011)
Light goods vehicles (LGVs) are an important part of the vehicle fleet, providing a vital component in the European transportation system. On the other hand, LGVs are in the focus of public discussion regarding road safety. In order to analyse the accident situation of LGVs in an objective manner, Federal Highway Research Institute (BASt), VDA, DEKRA and German Insurers Accident Research (UDV) launched a joint project. The aim of this project, which will be finished by mid of 2011, is to identify reasonable measures which will further improve the safety of LGVs. For the first time, these partners jointly together conducted a research project and put together their know-how in accident research. Analyses are based on real-life accident data from the GIDAS database, the Accident Database of UDV (UDB), the DEKRA database and national statistics. The findings deliver answers to questions within the arena of future legislative actions and consumer protection activities. The analyses of databases cover areas of primary and secondary safety of LGVs with a special focus on advanced driver assistance systems (ADAS), driver behaviour as well as partner and occupant protection. Key figures from national statistics are used to highlight hotspots of accidents of LGVs in Germany. Finally, the proposed countermeasures are assessed regarding their potential effectiveness. Amongst others, the results show that the accident situation of LGVs is very similar to that of passenger cars. Noteworthy variations could be found in collisions with pedestrians, at reversing and regarding accident causes. Occupant safety of LGVs is on a higher level compared to cars. Results indicate that seatbelt use is on a significantly lower level compared to cars. This leads to higher-than-average injury risk for unbelted LGV occupants. When it comes to partner protection, there are problems with compatibility at LGVs. For car occupants there is a very high injury risk when colliding with a LGV. It indicates that higher passive safety test standards for LGVs would be counterproductive if they further increase stiffness of LGVs. The analysis of LGV-pedestrian accidents shows that pedestrian kinematic differs significantly from car-pedestrian accidents. At this point, existing pedestrian related test standards developed for cars cannot be adopted to LGVs. When it comes to active safety, ESC proved its effectiveness once again. Beyond that, rear view cameras, advanced emergency braking systems and lane departure warning systems show a safety potential, too. In addition to any technical countermeasures previously discussed, the importance of the driver behavior and attitude regarding the accident risk was investigated. In order to develop successful actions it is important to understand the main target population. In the case of LGV especially the crafts business and smaller companies are the major contributors the safety issue.
Seilverspannte Brücken
(2008)
Der Beitrag behandelt den Entwurf, Besonderheiten der Berechnung und die Bemessung der beiden wichtigsten Bauarten seilverspannter Brücken, der echten Hängebrücke und der Schrägseilbrücke. Bei den Hängebrücken wird zunächst eingegangen auf die geschichtliche Entwicklung, die geprägt ist durch die im Zuge der Verbesserung des Stahls zunehmende Drahtfestigkeit. Anschliessend geht der Bericht ein auf: statisches System, Arten des Ueberbaus, Ausführung der Pylone, Kabel, Hänger und Widerlager. Analog zu den Hängebrücken ist der Beitrag bei den Schrägseilbrücken aufgebaut: geschichtliche Entwicklung, Haupttragwerke, Ueberbau, Pylone und Schrägseile. Hinsichtlich der Besonderheiten der Berechnung werden angesprochen: Anwendung der Theorie II. Ordnung und Betriebsfestigkeitsbeanspruchung. Erläutert wird auch die Montage sowohl der Hängebrücke als auch der Schrägseilbrücke in Wort und Bild.