91 Fahrzeugkonstruktion
Filtern
Erscheinungsjahr
- 2011 (15) (entfernen)
Dokumenttyp
- Konferenzveröffentlichung (10)
- Buch (Monographie) (4)
- Arbeitspapier (1)
Schlagworte
- Conference (10)
- Konferenz (10)
- Deutschland (9)
- Germany (9)
- Safety (6)
- Sicherheit (6)
- Fahrzeug (5)
- Vehicle (5)
- Anfahrversuch (4)
- Impact test (veh) (4)
Institut
Thoracic injury is one of the predominant types of severe injuries in frontal accidents. The assessment of the injury risk to the thorax in the current frontal impact test procedures is based on the uni-axial chest deflection measured in the dummy Hybrid III. Several studies have shown that criteria based on the linear chest potentiometer are not sensitive enough to distinguish between different restraint systems, and cannot indicate asymmetric chest loading, which has been shown to correlate to increased injury risk. Furthermore, the measurement is sensitive to belt position on the dummy chest. The objective of this study was to evaluate the optical multipoint chest deflection measurement system "RibEye" in frontal impact sled tests. Therefore the sensitivity of the RibEyesystem to different restraint system parameters was investigated. Furthermore, the issue of signal drop out at the 6 th rib was investigated in this study.A series of sled tests were conducted with the RibEye system in the Hybrid III 50%. The sled environment consisted of a rigid seat and a standard production three-point seat belt system. Rib deflections were recorded with the RibEye system and additionally with the standard chest potentiometer. The tests were carried out at crash pulses of two different velocities (30 km/h and 64 km/h). The tests were conducted with different belt routing to investigate the sensitivity of chest deflection measurements to belt position on the dummy chest. Furthermore, different restraint system parameters were investigated (force limiter level, with or without pretensioning) to evaluate if the RibEye measurements provide additional information to distinguish between restraint system configurations . The results showed that with the RibEye system it was possible to identify the effect of belt routing in more detail. The chest deflections measured with the standard chest potentiometer as well as the maximum deflection measured by RibEye allowed the distinction to be made between different force limiter levels. The RibEye system was also able to clearly show the asymmetric deflection of the rib cage due to belt loading. In some configurations, differences of more than 15 mm were observed between the left and side areas of the chest. Furthermore, the abdomen insert was identified as source of the problem of signal drop out at the 6th rib. Possible solutions are discussed. In conclusion, the RibEye system provided valuable additional information regarding the assessment of restraint systems. It has the potential to enable the evaluation of thoracic injury risk due to asymmetric loading. Further investigations with the RibEye should be extended to tests in a vehicle environment, which include a vehicle seat and other restraint system components such as an airbag.
Elektronik und IT werden auch im Automobilbereich zunehmend Gegenstand unautorisierter Veränderungen. Diese Studie stellt einen ersten, breiteren Überblick über die praktische Relevanz elektronischer Veränderungen an Fahrzeug- und Infrastruktursystemen dar. Es liefert einen Überblick über wesentliche bekannte und existente Beispiele von Möglichkeiten derartiger Veränderungen, das Risiko ihres Auftretens und damit verbundene Gefahren. Die Ergebnisse basieren auf einer Recherche, die neben wissenschaftlichen Quellen insbesondere das Internet als neues, interaktives Medium einbezieht. Es werden Abschätzungen zur praktischen Relevanz dieser Veränderungen vorgenommen und potentielle Folgen insbesondere für die Verkehrssicherheit reflektiert. Praktische Hinweise auf elektronische Veränderungen sind an 24 Fahrzeug- und Infrastruktursystemen dokumentiert, die als Ziel teils mehrerer Arten von elektronischen Veränderungen identifiziert wurden. Dies erstreckt sich über verschiedene Domänen wie u.a. den Antriebstrang, das Fahrwerk, Infotainment, Fahrerassistenz und mehrere Infrastrukturkomponenten. Diese Systematisierung enthält zudem eine Klassifikation der agierenden Personen, wobei deren individuelle Motivationen, technische Kenntnisse und Ausstattung unterschieden werden. Das Spektrum potentiell resultierender Gefahren wird einerseits theoretisch anhand der erstellten Systematisierungen aufgezeigt und andererseits an 19 Rechercheergebnissen aus verschiedenen Bereichen illustriert. Die so vorgenommene Analyse des Gefährdungspotentials wird ergänzt durch einen Ausblick auf potentielle zukünftige Gefährdungen, die sich insbesondere in kommenden Car-to-Car Kommunikationsnetzen ergeben könnten und die weitere Erforschung von Schutzkonzepten motivieren. Während die recherchierten Veränderungen heute noch meist vom Nutzer ausgehen und das Gefährdungspotential häufig unbeabsichtigt entsteht, könnte zukünftig das vorsätzliche Herbeiführen von Gefährdungen an Bedeutung gewinnen.
The ASSESS project is a collaborative project that develops test procedures for pre-crash safety systems like Automatic Emergency Braking (AEB). One key criterion for the effectiveness of e.g. AEB is reduction in collision speed compared to baseline scenarios without AEB. The speed reduction for a given system can only be determined in real world tests that will end with a collision. Soft targets that are crashable up to velocities of 80 km/h are state of the art for these assessments, but ordinary balloon cars are usually stationary targets. The ASSESS project goes one step further and defines scenarios with moving targets. These scenarios define vehicle speeds of up to 100 km/h, different collision scenarios and relative collision speeds of up to 80km/h. This paper describes the development of a propulsion system for a soft target that aims to be used with these demanding scenario specifications. The Federal Highway Research Institute- (BASt-) approach to move the target is a self-driving small cart. The cart is controlled either by a driver (open-loop control via remote-control) or by a computer (closed-loop control). Its weight is limited to achieve a good crashability without damages to the test vehicle. To the extent of our knowledge BASt- approach is unique in this field (other carts cannot move at such high velocities or are not crashable). This paper describes in detail the challenges and solutions that were found both for the mechanical construction and the implementation of the control and safety system. One example for the mechanical challenges is e.g. the position of the vehicle- center of gravity (CG). An optimum compromise had to be found between a low CG oriented to the front of the vehicle (good for driveability) and a high CG oriented to the rear of the vehicle (good for crashability). The soft target itself which is also developed within the ASSESS project will not be covered in detail as this is work of a project partner. Publications on this will follow. The paper also shows first test results, describes current limitations and gives an outlook. It is expected that the presented test tools for AEB and other pre-crash safety systems is introduced in the future into consumer testing (NCAP) as well as regulatory testing.
The 2BeSafe project (2-Wheeler Behaviour and Safety) is a collaborative project (co financed by the European Commission) that aims to study the naturalistic behaviour of Powered-Two-Wheeler (PTW) riders in normal and critical riding situations. That includes the interaction between PTW riders and other road users and possible conflicts between them. One of the predominant causes of accidents involving PTWs is that PTWs are often overlooked by other road users. One task of the project lead by BASt therefore deals with possible improvements in conspicuity and the development of recommendations. Particularly using the findings of the studies on conflict situations, promising lighting arrangements to enhance conspicuity of PTWs during the day and at night are selected. An abstract recognizing pattern for PTWs is defined, enabling other road users (e.g. car drivers) to clearly identify riders. Lamps and outfit like lighting configurations of different colours, different helmet lights, reflect / luminescent clothing parts and retro-reflective markings are designed and manufactured. Then, the different solutions are tested in a laboratory setting using experimental motorcycles together with riders to which the equipment is fitted. As result a proposal for a uniform signal pattern or lamp configuration in the front of all motorcycles and riders will be outlined. The contribution first gives a short overview of the topics of the research project that deal with conflicts and their connection with poor conspicuity and then presents in detail the methods used in the activities concerning solutions for the improvement of conspicuity together with first results.
Um die zukünftige Entwicklung von Fahrzeugen mit alternativem Antrieb, z.B. Hybrid-, Elektro- und Brennstoffzellenfahrzeuge, in Deutschland verfolgen und analysieren zu können, hatte die Bundesanstalt für Straßenwesen (BASt) im Jahr 2010 die Einrichtung einer langfristigen Beobachtung des Fahrzeugmarktes und einer konzentrierten Beobachtung des Unfallgeschehens initiiert, mit den Zielen, die tatsächliche Umsetzung des technologischen Fortschritts in marktgängige Produkte zu verfolgen, frühzeitig genaue Kenntnis über die sich der technologischen Entwicklung anschließenden tatsächlichen Marktentwicklung zu gewinnen, und mögliche Fehlentwicklungen - insbesondere mit Blick auf die Verkehrssicherheit zeitnah zu identifizieren. Auf Basis der bisherigen Marktentwicklung ist die Analyse des Unfallgeschehens naturgemäß noch wenig aussagekräftig. Die deutliche Zunahme der Unfallbeteiligung von Hybridfahrzeugen um 95% von 2007 bis 2010 wird durch einen Bestandsanstieg von 117% in diesem Zeitraum relativiert und deutet daher eher auf ein unterdurchschnittliches Risiko, wobei keine Informationen über die durchschnittliche Fahrleistung in die Interpretationen einbezogen werden können. Der relativ hohe Anteil von Innerortsunfällen ist vor allem vor dem Hintergrund der Nutzung der Fahrzeuge zu interpretieren.