Filtern
Erscheinungsjahr
Dokumenttyp
- Konferenzveröffentlichung (188)
- Buch (Monographie) (158)
- Wissenschaftlicher Artikel (73)
- Arbeitspapier (14)
- Teil eines Buches (Kapitel) (7)
- Bericht (4)
Schlagworte
- Unfall (444) (entfernen)
The "Seven Steps Method" is an analysis and classification system, which describes the human participation factors and their causes in the temporal sequence (from the perceptibility to concrete action errors) taking into consideration the logical sequence of individual basic functions. By means of the "seven steps" it is possible to describe the relevant human causes of accidents from persons involved in the accident in an economic way with a sufficient degree of exactitude, because the causes can be further differentiated in their value (e.g. diversion as external diversion with regard to impact due to surroundings) and their sub values (e.g. external diversion with regard to impact due to surroundings in the shape of a "capture" of the perception by a prominent object of the traffic environment). Theoretically it is possible that one or more causing moments can be assigned to a person involved in an accident in each of the "seven steps"; however it is also possible to sufficiently clarify the cause in only one level (examples for this are described). In the practice of accident investigation at the site of the accident, the sequence chart is also relevant. With its assistance the questioning of the people involved in an accident can be accomplished in a structured way by assigning a set of questions to each step.
The European Union has set a target to reduce all road fatalities (over 40,000) with 50% in 2010. This target percentage remained unchanged with the introduction of the ten new member states within the EU as by May 1st, 2004. According to Eurostat, 34% of all fatalities in 1998 in the, then, fifteen states of the European Union were the result of single vehicle collisions. This represents over 14,000 lives lost each year of which many can likely be saved through better roadside infrastructure design. The challenge for road safety professionals is to find methods and design strategies that help to reduce these casualties. Procedures for full-scale vehicle crash testing of guard rails were first published in the US in 1962. Present European regulation is mainly based on these procedures and later developments. Since then the vehicle fleet has changed considerably. Due to the complexity of the actual safety problem the numerical simulation approach offers a good opportunity to evaluate the different parameters involved in road safety, such as infrastructure properties, vehicle type, vehicle occupants and injuries. The ideal situation would be that simulation tools are coupled or integrated and all involved effects would be related. At the moment this is not the case yet, but initiatives are taken and a new virtual era has started. This paper offers a method looking at two components that encompass the driving environment: the car and the guardrail. As part of the EC-funded project, RISER (Roadside Infrastructure for Safer European Roads) a multi body simulation program study is carried out to determine sensitivities of some parameters in car to guardrail collisions and gives insides in performance of the car with passive safety equipment, the guardrail and the interaction of these objects with each other. By offering a set of methods that includes these two aspects and their intertwining relations, more confidence can be gained in actually reducing fatalities due to single vehicle collisions with, or due to, roadside furniture. Reducing the number of fatalities of single vehicle crashes would contribute greatly to the stated goal of reducing casualties altogether.
Due to recent years accident avoidance and crashworthiness on Austrian roads were mostly developed on national statistics and on-scene investigation respectively. Identification and elimination of black spots were main targets. In fact many fatal accidents do not occur on such black spots and black-spot investigation has reached a limit. New methods are required and therefore the Austrian Road Safety Programme was introduced by the Austrian Ministry of Transport, Innovation and Technology. The primary objective is the reduction of fatalities and severe injuries. Graz University of Technology initiated the project ZEDATU (Zentrale Datenbank tödlicher Unfälle) with the goal to identify similarities in different accident configurations. A matrix was established which categorizes risk and key factors of participating parties. Based on this information countermeasures were worked out.
NASS: the glass is half full
(2007)
The National Accident Sampling System (NASS) was born in the late 1970s. It was based on a substantial amount of experience and analysis of what was needed in the United States to understand the safety challenges of our highways. This work also showed how to collect high quality and useful crash data efficiently. Unfortunately, when Ronald Reagan - a President who believed in limited government - was elected, any hope of full funding for NASS was lost. The concept of 75 teams investigating about 18,000 serious crashes in detail annually was never realized. The system got up to 50 teams, then was cut to 36, and finally to 24 teams investigating fewer than a quarter of the originally anticipated number of crashes per year. Despite this, the NASS investigations provide a rich source of data, collected according to a sophisticated statistical sampling system to facilitate detailed national estimates of road casualties on our nation- highways and their causes. In addition, changes have been made in recent years to increase the number of more serious crashes of recent model vehicles to make the results more relevant to improving vehicle safety. A recent, detailed examination of hundreds of rollovers has provided considerable insight into rollover casualties and into what can be done to reduce them. Some of these results will be presented that show the value of the NASS system. Our experience with NASS and the Fatal Accident Reporting System (FARS) suggests a number of improvements that could be made in the United States" crash data systems. It also provides justification for a doubling or tripling of our national expenditures on crash data collection.
This study aimed to identify the occurrence, type and mechanisms of the traumatic injuries of the vulnerable road users in vehicle collisions, and to determine the effects of human, engineering, and environment factors on traffic accidents and injuries. The pedestrian accident cases were collected in the years 2000 to 2005 from Changsha Wujing hospital China and Accident Research Unit at Medical University Hannover in Germany. A statistic analysis was carried out using the collected accident data. The results from analysis of Changsha data were compared with results from analysis of GIDAS data Hannover. The injury severities were determined using AIS code and ISS values. The results were presented in terms of cause of injuries, injury distributions, injury patterns, injury severity. The factors influenced the injury outcomes were proposed and discussed for the vehicle transport environment and road users. The results were discussed with regard to accident data collection, accident sampling and injury distributions etc. In the urban area of Changsha, motorcycles and passenger cars are most frequently involved in vehicle pedestrian accidents. Head and lower extremities injuries are the predominant types of pedestrian injuries. The pedestrian accidents were identified as vital issue in urban traffic safety and therefore a high priority should be given to this road user group in research of safe urban transportation. In Hannover area, cars are most frequently involved in traffic accidents, injured pedestrians are involved in road traffic of Germany in 13% of all causalities only in 2005 and have nearly the same number as motorcyclists, but the half of bicyclists.
In recent years the boundaries between active and passive safety blurred more and more. Passive safety in the traditional term includes all safety aspects to prevent occupants to be injured or at least injury severity should be reduced. Passive Safety starts with the collision (first vehicle contact) and ends with rescue (open vehicle doors). Within this phase the occupant has to be protected by the passenger compartment whereby no intrusion should occur. Active safety on the other side was developed to interact prior to the collision whereby the goal is to prevent accidents. The extensive interaction between active and passive safety led to the terminologies "Primary" and "Secondary" safety whereas the expression Integrated Safety Concept was generated. Within this study the most well documented single vehicle accidents with cars not equipped with ESP were identified from the PENDANT database and reconstructed. Additional cases were found in the database ZEDATU of TU Graz. In comparison each case was simulated with the assumption that the cars were equipped with ESP. The differences regarding accident avoidance or crash severity as well as reduction of injury risk were analysed.
There is a need for detecting characteristics of pedestrian movement before car-pedestrian collisions to trigger a fully reversible pedestrian protection system. For this purpose, a pedestrian sensor system has been developed. In order to evaluate the effectiveness of the sensor system, the in-depth knowledge of car-pedestrian impact scenarios is needed. This study aims at the evaluation of the sensor system. The accident data are selected from the STRADA database. The accident scenarios available in this database were evaluated and the knowledge of the most common scenarios was developed in terms of the pedestrian trajectory, the pedestrian speed, the car trajectory, the car velocity, etc. A mathematical model was then established to evaluate the sensor system with different detective angles. It was found that in order to detect all the pedestrians in the most common scenarios on time the sensor detective angle must be kept larger than 60 degrees.
Since 2005 the German In-Depth Accident Study (GIDAS) also records aspects of active vehicle safety. This is done because vehicles are fitted with an increasing number of active safety devices which have undoubtedly an influence on the number, severity and course of accidents. Accident researchers expect that collecting active safety data will facilitate to assess and quantify the impact of these and future devices. It is the aim of this paper to outline benefits and limitations associated with the recording of active safety aspects within indepth studies. An overview about possible areas where active safety data can be useful will be given. For that purpose single safety or comfort systems will be selected to estimate the effects of an accident database which includes variables associated with these systems. Questions with regard to the limitations of collecting active safety data will be addressed. Possible items are for example the usability of the data recorded, the real accident cause, the small number of relevant accidents, the time span needed to gather a sufficient dataset, the small share of vehicles equipped with a certain system or different functionalities of systems that are supposed to fall in the same category. As a result user needs for a reasonable data collection of active safety elements will be elaborated.
Description of road traffic related knee injuries in published investigations is very heterogeneous. The purpose of this study was to estimate the risk of knee injuries in real world car impacts in Germany focusing vulnerable road users (pedestrians, bicyclists and motorcyclists) and restrained car drivers. The accident research unit analyses technical and medical data collected shortly after the accident at scene. Two different periods (years 1985-1993 and 1995-2003) were compared focusing on knee injuries (Abbreviated Injury Scale (AISKnee) 2/3). In order to determine the influences type of collision, direction and speed as well as the injury pattern and different injury scores (AIS, MAIS, ISS) were examined. 1.794 pedestrians, 742 motorcyclists, 2.728 bicyclists and 1.116 car drivers were extracted. 2% had serious ligamentous or bony injuries in relation to all injured. The risk of injury is higher for twowheelers than for pedestrians, but knee injury severity is higher for the latter group. Overall the current knee injury risk is low and significant reduced comparing both time periods (27%, p<0,0001). Severe injuries (AISKnee 2/3) were below 1%). Improved aerodynamic design of car fronts reduced the risk for severe knee injuries significantly (p=0,0015). Highest risk of injury is for motorcycle followed by pedestrians, respectively. Knee protectors could prevent injuries by reducing local forces. The classically described dashboard injury was rarely identified. The overall injury risk for knee injuries in road traffic is lower than estimated and reduced comparing both periods. The aerodynamic shape of current cars compared to older types reduced the incidence and severity of knee injuries. Further modification and optimization of the interior and exterior design could be a proper measurement. Classic described injury mechanisms were rarely identified. It seems that the AIS is still underestimating extremity injuries and their long term results.
The present report is a compilation of the evaluation results obtained by the end of 2009 in respect of the experimental novice driver training models "Voluntary further training seminars for novice drivers" (here: "VFT" model"). The models were initially introduced by the legislator on a trial basis in 2003 and 2005 respectively, and were to be evaluated and tested with regard to their road safety effectiveness prior to making a decision on the permanent integration into the driver licensing system. Alongside the question of road safety effectiveness (summative evaluation), the evaluation studies also analysed the experience gained from practical implementation of the individual concepts (process/formative evaluation). Whereas the safety impact is of direct significance for the decision on permanent adoption of the models, the results of the process evaluation are important independently of this decision for considerations of the possibilities for concept optimisation. The evaluation studies conducted by the Federal Highway Research Institute (BASt) were spread over a total of six sub-projects; complete and conclusive results are available for five of these sub-projects. The evaluation of the VFT model was unable to confirm the road safety effectiveness of this approach. It is especially disturbing to learn that participants in the VFT model display a significantly greater risk of accident involvement and traffic offences compared to novice drivers of the same age and with similar driving experience who have not attended a VFT seminar. Possible causes, insofar as a directly causal effect of the VFT participation is excluded, can most reasonably be assumed to lie in the curtailed effectiveness of the probationary licence rules in the case of VFT participants (participation is honoured with a shortening of the probationary period by up to one year) and self-selection effects in conjunction with VFT participation (model may attract above all those novice drivers with a tendency to conspicuous driving behaviour, as a means to achieve a shortening of the probationary period). In view of the significantly poorer driving behaviour of the VFT participants, and against the background of the aforementioned plausibility considerations regarding the underlying causes, however, it seems expedient to already now remove the incentive of a shorter probationary period in case of VFT participation. The evaluation of practical implementation of the VFT model revealed the need for further development of several points. This refers to the quality of the active, attitude-building training forms to be applied by the seminar leaders and moderators, as well as questions concerning optimised seminar organisation in the interest of training quality. It is here recommended that the seminar concept be subjected to a thorough review, and that the conditions for concept-adequate implementation be improved.