Abteilung Fahrzeugtechnik
Filtern
Erscheinungsjahr
Dokumenttyp
- Konferenzveröffentlichung (97)
- Buch (Monographie) (49)
- Wissenschaftlicher Artikel (45)
- Arbeitspapier (13)
- Teil eines Buches (Kapitel) (5)
Sprache
- Englisch (106)
- Deutsch (101)
- Mehrsprachig (2)
Schlagworte
- Safety (77)
- Sicherheit (76)
- Fahrzeug (57)
- Vehicle (57)
- Bewertung (51)
- Deutschland (46)
- Germany (46)
- Anfahrversuch (45)
- Evaluation (assessment) (45)
- Impact test (veh) (42)
Institut
- Abteilung Fahrzeugtechnik (209) (entfernen)
Today, Euro NCAP is a well established rating system for passive car safety. The significance of the ratings must however be evaluated by comparison with national accident data. For this purpose accidents with involvement of two passenger cars have been taken from the German National Road Accident Register (record years 1998 to 2004) to evaluate the results of the NCAP frontal impact test configuration. Injury data from both drivers involved in frontal car to car collisions have been sampled and have been compared, using a "Bradley Terry Model" which is well established in the area of paired comparisons. Confounders " like mass ratio of the cars involved, gender of the driver, etc. " have been accounted for in the statistical model. Applying the Bradley Terry Model to the national accident data the safety ranking from Euro NCAP has been validated (safety level: 1star <2 star <3 star <4 star). Significant safety differences are found between cars of the 1 and 2 star category as compared to cars of the 3 and 4 star category. The impact of the mass ratio was highly significant and most influential. Changing the mass ratio by an amount of 10% will raise the chance for the driver of the heavier car to get better off by about 18%. The impact of driver gender was again highly significant, showing a nearly 2 times lower injury risk for male drivers. With regard to the NCAP rating drivers of a high rated car are more than 2 times more probable (70% chance) to get off less injured in a frontal collision as compared to the driver of a low rated car.
Proposal for a test procedure of assistance systems regarding preventive pedestrian protection
(2011)
This paper is showing a proposal for a test procedure regarding preventive pedestrian protection based on accident analysis. Over the past years pedestrian protection has become an increasing importance also during the development phase of new vehicles. After a phase of focusing on secondary safety, there are current activities to detect a possible collision by assistance systems. Such systems have the task to inform the driver and/or automatically activate the brakes. How practical is such a system? In which kind of traffic situations will it work? How is it possible to check the effectiveness of such a system? To test the effectiveness, currently there are no generally approved identifiable procedures. It is reasonable that such a test should be based on real accidents. The test procedure should be designed to test all systems, independent of the system- working principle. The vFSS group (advanced Forward-looking Safety Systems) was founded to develop a proposal for a technology independent test procedure, which reflects the real accident situation. This contribution is showing the results of vFSS. The developed test procedure focuses on accidents between passenger cars and pedestrians. The results are based on analysis results of in-depth databases of GIDAS, German insurers and DEKRA and added by analysis of national and international statistics. The in-depth analysis includes many pre-crash situations with several influencing factors. The factors are e. g. speed of the car, speed of the pedestrian, moving direction and a possible obscuration of the pedestrian by an object. The results comprise also the different situations of adults and children. Furthermore, they include details regarding influence of the lighting conditions (daylight or night) especially with respect to the accident consequences. In fact, more accidents happen at daylight, but fatal accidents are more often at night. A clustering of parameter combinations was found which represents typical accident scenarios. There are six typical accident scenarios which were merged in four test scenarios. The test scenarios are varying the starting position of the pedestrian, the pedestrian size (adult or child) and the speed of the pedestrian, whereas the speed of the car will not be varied. To ensure the independency from used sensing technologies it is necessary to use a suitable dummy. For example, if sensors are based on infrared, the dummy should emit the temperature of a human being. The test procedure will identify the collision speed as the key parameter for assessing the effectiveness of the tested system. The collision speed is defined as the reduction between initial test speed of the car and impact speed. The assessment of the speed reduction value regarding the safety benefit, however, will be part of a separate procedure.
In line with the new definition introduced by the European Commission (EC), the number of seriously injured road casualties in Germany for 2014 is assessed in this study. The number of MAIS3+ casualties is estimated by two different methodological approaches. The first approach is based on data from the German Inâ€Depth Accident Study (GIDAS), which is closely related to the German Road Traffic Accident Statistics. The second approach is based on data from the German TraumaRegister DGU-® (TRâ€DGU), which includes many more hospitals but not all MAIS3+ injuries.
Vor dem Hintergrund der derzeitigen Verkehrs- und Unfallsituation sowie verkehrsrechtlicher Vorschriften wurde durch Auswertung humanwissenschaftlicher und technischer Literatur eine Sachstandsbeschreibung erstellt, die die in Zusammenhang mit Auffahrunfällen und ihrer Verhinderung stehenden Aspekte aufzeigt. Als fahrzeugtechnische Hilfen zur Einhaltung eines ausreichenden Abstandes zwischen hintereinander fahrenden Fahrzeugen werden dabei vorrangig autarke Systeme - das sind solche, bei denen sich alle notwendigen Vorrichtungen im Fahrzeug befinden - betrachtet. Möglichkeiten und Grenzen der bekannten technischen Hilfsmittel, insbesondere der Abstandswarn- und Abstandsregelungseinrichtungen werden aufgezeigt. Es stellte sich heraus, dass den Warnstrategien sowie ihren Auswirkungen auf den Verkehrsablauf und die Verkehrssicherheit besondere Bedeutung zukommt. In diesem Zusammenhang werden auch Zielkonflikte, insbesondere zwischen Sicherheitsforderungen und Fahrerakzeptanz, deutlich. Im Teil I des Berichts erfolgt die zusammenfassende Beschreibung und kritische Wertung des Sachstandes. Im Teil II werden die Auswerteergebnisse zu den angesprochenen Fragenkomplexen im einzelnen dargestellt. Teil III enthält eine Kurzdokumentation der für die Erstellung des Berichts wesentlichsten Literaturstellen.
In der BRD hatten 1977 etwa 39.000 bis 46.000 Pkw einen Brandschaden durch Flammen- und/oder Glutwirkung. Der Sachschadenaufwand der Kraftfahrzeugversicherer betrug 52 Mio. DM. Schwere Personenschäden sind vorwiegend bei unfallbezogenen Fahrzeugbränden entstanden. 1977 wurden ca. 55 bis 80 Personen durch Fahrzeugbrand getötet, maximal 450 schwer verletzt. Etwa 90 % der Brände entstehen infolge technischer Mängel, Fahrlässigkeit und Brandstiftung. Auf Wunsch der Käufer werden etwa 10 % der Pkw mit tragbaren Feuerlöschern ausgerüstet. Der Zwei-Kilo-Löscher hat sich als derzeit günstiger Löscher herausgestellt. Welchem Löschmittel der Vorzug zu geben ist, wurde von Experten nicht eindeutig beantwortet. Die Gesamtwirksamkeit des Zusammenhanges Brandgeschehen-Mensch-Feuerlöschgerät verdeutlicht, dass eine allgemeine Ausrüstungspflicht aller Pkw mit tragbaren Feuerlöschern aus gesamtwirtschaftlicher Sicht nicht zu befürworten ist. Das freiwillige Ausrüsten von Fahrzeugen sollte dagegen weiter propagiert werden.
Powered Two Wheelers (PTWs) accidents constitute one of the road safety problems in Europe. PTWs fatalities represent 22% at EU level in 2006, having increased during last years, representing an opposite trend compared to other road users" figures. In order to reduce these figures it is necessary to investigate the accident causation mechanisms from different points of view (e.g.: human factor, vehicle characteristics, influence of the environment, type of accident). SAFERIDER project ("Advanced telematics for enhancing the SAFEty and comfort of motorcycle RIDERs", under the European Commission "7th Framework Program") has investigated PTW accident mechanisms through literature review and statistical analyses of National and In-depth accident databases; detecting and describing all the possible PTW's accident configurations where the implementation of ADAS (Advanced Driver Assistance Systems) and IVIS (In-Vehicle Information Systems) could contribute to avoid an accident or mitigate its severity. DIANA, the Spanish in-depth database developed by CIDAUT, has been analyzed for that purpose. DIANA comprises of accident investigation teams, in close cooperation with police forces, medical services, forensic surgeons, garages and scrap yards. An important innovation is the fact that before injured people arrive to hospitals, photographs and explanations about the possible accident injury mechanisms are sent to the respective hospitals (via 3G GPRS technology). By this, additional information to medical staff can be provided in order to predict in advance possible internal injuries and select the best medical treatment. This methodology is presented in this paper. On the other hand, the main results (corresponding to road, rider and PTW characteristics; pre and post-accident manoeuvres; road layout; rider behaviour; impact points; accident causations;...) from the analyses of the PTW accidents used for SAFERIDER are shown. Only accident types relevant to ADAS and IVIS devices have been considered.
In nahezu allen Ländern wurde die Gurtanlegepflicht von Anfang an mit einer finanziellen Sanktion verbunden. Nur in Norwegen und Schweden ist bei Einführung der Gurtanlegepflicht auf eine Sanktionsbewehrung verzichtet worden. Im Jahre 1979 hat Norwegen dann eine Sanktion nachträglich eingeführt und ist insoweit für die Beurteilung der Wirksamkeit der nachträglichen Maßnahme der einzige unmittelbare Vergleichsfall. Es zeigte sich gegenüber der schon bestehenden Anlegepflicht ohne Sanktionsbewehrung ein starker Anstieg der Anlegequoten, insbesondere auf Innerortsstraßen. In mehreren Ländern wurde die Einführung der Gurtanlegepflicht mit umfassenden Informationen über den Nutzen des Sicherheitsgurtes eingeleitet. Bei der Erteilung von Ausnahmegenehmigungen werden unterschiedlich strenge Maßstäbe angelegt; in der Schweiz wurden zur Sicherung gegen allzu leichtes umgehen der Gurtanlegepflicht wirksame Kriterien entwickelt. Von wenigen Extremfällen abgesehen, liegt die Höhe der Sanktion im Mittel bei etwa 50,- DM.
Erkenntnisse über den Nutzen zusätzlicher hochgesetzter Bremsleuchten sind lückenhaft und zum Teil widersprüchlich. Im Rahmen einer Untersuchung über den Einfluss zusätzlicher Bremsleuchten auf das Unfallgeschehen wurden u.a. folgende Fragen behandelt: 1. Entwicklung der Unfälle durch Auffahren auf Fahrzeuge, die mit zusätzlichen Bremsleuchten ausgerüstet sind, 2. Entwicklung der Auffahrunfälle insgesamt, 3. Verletzungen von Fahrzeuginsassen durch Leuchten, 4. Auswirkungen auf die übrigen Verkehrsteilnehmer (Abstand, Blendung, Fehlreaktion). Anhand konkreter Daten über das Unfallgeschehen in Bayern und Niedersachsen kommt der Beitrag insgesamt zu dem Urteil, dass die derzeitige Regelung weder durch eine Einbauvorschrift noch durch ein Einbauverbot hochgesetzter Bremsleuchten ersetzt werden müsste.
Stellungnahme zu einer Ausdehnung der Schutzhelmtragepflicht auf Moped/Mokick- und Mofabenutzer
(1977)
Im Hinblick auf die Unfallentwicklung bei motorisierten Zweiradfahrern wurde eine Untersuchung zur Ausdehnung der Verpflichtung, einen Schutzhelm zu tragen, auf Moped/Mokick- und Mofafahrer durchgeführt. Die Unfallschwere bei Außerortsunfällen ist hervorzuheben. Dabei handelt es sich überwiegend um Kopfverletzungen. Die Schutzwirkung von Helmen wird generell positiv eingeschätzt. Auf 1976 bezogen hätten bei Helmtragepflicht und 100 % Tragequote vermutlich rund 140 Tote, 2200 Schwerverletzte und 4400 Leichtverletzte eingespart werden können. Es wird empfohlen, die Helmtragepflicht zwingend vorzuschreiben. Nach den bisherigen Erfahrungen würde die Helmtragepflicht ohne Bußgeldbewehrung nicht auf die optimale Größenordnung angehoben werden können. Schutzhelme für motorisierte Zweiradfahrer sollten mindestens der DIN 4848 (1970) "Kraftfahrer-Schutzhelme" entsprechen, auch wenn die DIN 4848 noch nicht voll alle Forderungen an Schutzhelme abdeckt. Die Helmtragepflicht sollte so schnell wie möglich eingeführt werden. Die Einführung der Helmtragepflicht ist besonders auch unter gesamtwirtschaftlichen Gesichtspunkten sinnvoll.
A means of assessing the passive safety of automobiles is a desirable instrument for legislative bodies, the automobile industry, and the consumer. As opposed to the dominating motor vehicle assessment criteria, such as engine power, spaciousness, aerodynamics and consumption, there are no clear and generally accepted criteria for assessing the passive safety of cars. The proposed method of assessment combines the results of experimental safety tests, carried out according to existing legally prescribed or currently discussed testing conditions, and a biomechanical validation of the loading values determined in the test. This evaluation is carried out with the aid of risk functions which are specified for individual parts of the body by correlating the results of accident analysis with those obtained by computer simulation. The degree of conformance to the respective protection criterion thus deduced is then weighted with factors which take into account the frequency of occurrence and the severity of the accident on the basis of resulting costs. Each of the test series includes at least two frontal and one lateral crash test against a deformable barrier. The computer-aided analysis and evaluation of the simulation results enables a vehicle-specific overall safety index as well as partial and individual safety values to be determined and plotted graphically. The passive safety provided by the respective vehicle under test can be defined for specific seating positions, special types of accident, or for individual endangered parts of the body.