Refine
Document Type
- Conference Proceeding (3) (remove)
Has Fulltext
- no (3) (remove)
Keywords
- Reifen (3) (remove)
Institute
During a lifecycle a tyre undergoes degradations due to mechanical wear and chemical ageing which affect not only durability and safety but also tyre/road noise emission and rolling resistance. This paper presents a study with the purpose to study how much tyre/road noise and rolling resistance change when car tyres are worn down from the original 8 mm tread depth to 2 mm, and when chemical ageing of the tyre rubber is simulated by exposure to heat. Six car tyres of different types were selected for the study which were worn on a wear machine in steps of 2 mm tread depth. Before, between and after these wear sessions tyre/road noise and rolling resistance were measured on two drum facilities with different surface textures, including replicas of ISO surfaces. Additionally, coast-by and CPX measurements were made on outdoor ISO test tracks. The results show that the wear and age effect was low on ISO surfaces but dramatic (noise increased with wear) on the rough-textured surface and high but opposite on an extremely smooth surface.
Die Reduzierung des Straßenverkehrslärms ist in den letzten Jahren zunehmend in den Fokus der Forschungsaktivitäten gerückt. Laut einer Studie des Umweltbundesamts fühlen sich in Deutschland circa 60 % der Bevölkerung durch den Straßenverkehrslärm belästigt. Diese Zahl ist seit vielen Jahren konstant. Ein Grund dafür sind die steigenden Verkehrsmengen. Neben den bekannten gesundheitlichen Beeinträchtigungen wurden in den letzten Jahren auch zunehmend negative Auswirkungen des Verkehrslärms auf die Stadtentwicklung beobachtet. Die Bundesanstalt für Straßenwesen koordiniert seit über 10 Jahren die durch das Bundesministerium für Wirtschaft und Technologie geförderten Verbundprojekte "Leiser Straßenverkehr". Partner aus Industrie und Forschung verfolgen das gemeinsame Ziel, effektive Lösungen für eine Lärmreduzierung zu erarbeiten. In den letzten Jahren ist es gelungen, die Wirkmechanismen der Lärmentstehung im Zusammenspiel Reifen-Fahrbahn detailliert zu beschreiben und Anforderungen für eine dauerhafte Lärmreduzierung zu formulieren. In der Straßenbautechnik wurden Regelbauweisen lärmtechnisch optimiert und neue Bauweisen entwickelt. Zusammen mit Projektpartnern konnte die Firma Continental Reifen Deutschland GmbH Pkw- und Lkw-Reifen akustisch optimieren. Ein zentrales Ziel im Verbundprojekt Leiser Straßenverkehr 3 ist die Weiterentwicklung eines Simulationsmodells, um künftig unter Berücksichtigung verschiedener Einflussgrößen aus Reifen und Fahrbahn Geräuschprognosen zu ermöglichen.
The development of tyre- and truck-manufacturers leads to the direction to introduce wide base single tyres (size 495/45R22,5) instead of twin tyres on the driving axle of trucks, tractors and busses. To study the driving behaviour and safety of various trucks and units with different tyre combinations and loading conditions was the aim of the study. A computer-aided simulation was used for this investigation. Drive tests with a 40 t unit with prototype single tyres on the drive axle were carried out to verify the simulation. Alterations in driving behaviour and driving safety are mainly dependent on the tyre cornering stiffness. The prototype wide single tyres had a higher lateral stiffness which leads to a higher degree of under-steering (safer driving behaviour). The altered spring base on the drive axle had no influence on the side- tilt stability of vehicle combinations but the solo truck profited from the higher rear axle roll stiffness (less danger for roll-over accidents). As far as the driving safety is concerned nothing speaks against wide base tyres on the drive axle. The simulation of a tyre defect in a bend (assuming 40% of the max. transferable side force for the flat tyre) showed no increased danger using wide single tyres. Later driving tests showed however the need of tyre run flat possibilities to avoid jack-knifing of road trains. Also tyre pressure monitoring systems and electronic stability programs for the trucks are advised.